N150 12V - 152AhC20Hr - Dry Charged Battery

new

N150 12V - 152AhC20Hr - Dry Charged Battery

Peyman Group produces and manufactures all kinds of batteries with different sizes with the above quality compared to other companies in the country with a long history. In addition, our services are available nationwide.

Payman Battery Manufacturing Company is one Of the best and largest producers Of starter batteries (MF, dry) and tubular (solar) batteries in various capacities and sizes in Afghanistan. The company began its operations in 2023, relying on modern technical knowledge, skilled personnel, and advanced technology. It has adopted global standards ofr the production and manufacturing Of raw materials and battery components.

The company’s products are competitive with leading international models in terms Of perofrmance and are Of high quality.

Payman Battery Manufacturing Company, in addition to its high production capacity, possesses extensive expertise and capabilities in distribution and after-sales services.

Longer Lifespan
‌Better Perofrmance
National Production
Superior Quality
After Sales Service
One Year Warranty
Three Years Warranty

Battery specifications or BATTERY QUICK FACTS

CAPACITY MINUTES

N/A

Capacity AMP Hours

152AhC20Hr

Energy (KWH)

N/A

DIMENSIONS INCHES (MM)

Length: N/A

Width: N/A

Height: N/A

WEIGHT LBS (KG)

N/A

OPERATING TEMPERATURE

N/A

Number of Plates

Voltage

12V

DOCUMENTS

Preparation Of Battery Before Use:

Remove Battery from Carton Box, Check for any Damage. If Damaged, Return the Battery at Once.
Remove Vent Caps or foil, Fill in Sulfuric Acid (Recommended for 1.250-1.260) Until Reaching Upper Level Indicated on The Battery.
Even The Battery Contains Dry-Charged Ability, It Is Recommended That Initial Charging At 1/10 Of Capacity Will Extend the Life of the Battery.
Check The Electrolyte Level, If Below Lower-Level Top Up with Distilled Water to Reach Upper Level.
Check The Specific Gravity of The Electrolyte as Recommended.
Replace Vent Caps, Remove Tape on Each Caps (If Any), Wash and Wipe Dry.
Battery Is Now Ready for Installation.

Installation of Battery on Vehicle:

Then Positive. Unfastened The Battery Holding Rods and Take

Remove The Old Battery by Disconnecting Negative Pole First Battery Out of Vehicle.
Clean The Connectors by Hot Water and Paste Thin Grease Before Putting New Battery on Vehicle.
Fasten Up the Battery Holding Rods. Make Sure That the Rods Are Not Too Tight Otherwise It May Damage the Battery.
Connect The Positive Connector to The Positive Pole of The Battery. Then Connect the Negative Connector to The Negative Pole of The Battery. (Caution: Do Not Connect Negative First!).
Recheck The Vent Caps, Tighten If Necessary.
Check Whether There Is No Any Tool Left in The Machine Room before Closing the Hood. Starts The Engine and Go.

Maintenance Of Battery in Operation:

Keep Checking Electrolyte Level At Least Once A Month. If The Electrolyte Level Is Below Lower Level, Add Distilled Water Until Reach Upper Level.
If Lights Dim, Horn Sounds Weak or Difficult to Start, A Boosting Charge Is Necessary.
If You Have to Add Distilled Water Too Often or The Battery Need Charging Too Often, A Check of Vehicle’s Electrical System Is Required.
Make Sure That the Ventilating Hole on Each Vent Plug Is Not Clogged Otherwise It May Explode.
If The Battery’s Poles and The Connectors of The Vehicle Are Dirty, Wash with Hot Water and Paste Thin Grease.
If The Battery Remains in Active for A Long Period of Time, A Boosting Charge At 1/10 Of Capacity Is Required At Least Once a Month.

Safety Instruction:

Danger – Causes Severe Burns, Contains Sulfuric Acid, Avoid Contact with Skin, Eyes or Clothing.

External – Flush with Large Amount of Water.

Internal – Drink Large Amount of Water Follow by Milk of Magnesia and Get Prompt Medical Attention.

Eyes – Flush with Large Amount of Water for 10 Minutes and Get Prompt Medical Attention.

Caution – May Explode, Battery Produces Explosive Gases, Keep Sparks, Flame, Cigarette Away. Ventilate When Charging or Using in Enclosed Space. Always Shield Eyes When Working with Battery.

Keep Out of Reach of Children